Learn How To Backwash A Pool Sand Filter In ten Simple Steps with this easy to follow guide! Follow the simple steps below and you can keep your pool filter maintained in no time!

When sand filter pumps are set to filter, water will flow from the pool, through the filter and and then dorsum into the pool. The sand that's in the filter organization will block dirt, oil, and debris. What results is a dirty and clogged filter that can reduce the power of the sand to filter the water and get information technology dorsum into your puddle.

How To Backwash A Pool Sand Filter In 10 Simple Steps

Backwashing will help your pool sand filter not go clogged. Pool water normally flows elevation to lesser in a sand filter, water enters at the peak of the tank and pushes down through the sand bed into the laterals at the bottom of the tank. During backwashing, the water flows in opposite, from bottom to top, out of the laterals and up thru the sand, to flush out the trapped dirt from the sand bed and send it out the waste line.

Learning how to aftermath a pool sand filter isn't that hard and should be done once the force per unit area displayed on your pressure gauge is eight-10 PSI over the starting level. It's besides skilful to backwash afterwards large storms, when the water gets cloudy, or when you've cleaned up an algae bloom.

How To Back Wash A Pool Sand Filter

How To Backwash A Pool Sand Filter In 10 Uncomplicated Steps

  1. Turn off the power to the pool pump at the excursion breaker earlier moving the multiport filter valve handle on the pump. This will prevent impairment to the plumbing, gasket & internal filter parts. It also ensures your safety.
  2. Unroll the backwash hose & make certain it is tightly clamped & laid out where you lot want the wastewater to go.
  3. Press downward fully on valve handle & rotate from the FILTER position to the BACKWASH position & lock it in place.
  4. Turn the power to the filter pump back on & run it for at least iii minutes. The water in the sight glass on the side of the valve should alter from cloudy to clear & the water coming out of the aftermath volition probably look dirty.
  5. Plough the power off once again to end the backwashing process.
  6. Depress the multiport filter valve handle, movement it from the Backwash position to the RINSE position & lock information technology there.
  7. Plough the power back on to showtime the rinse process and allow the pump to rinse the filter for 1 to 2 minutes.
  8. Turn the power off to stop the rinse process.
  9. Depress the multiport filter valve handle, move it from the RINSE position to the FILTER position & lock it at that place.
  10. Turn the ability to the pump back on for normal filter performance and Bank check your pressure level guess to ensure that the pressure has dropped viii-x PSI from where it was prior to the backwashing procedure.

That's information technology! You've successfully learned how to backwash your sand filter!

Click HERE To Shop Swimming Pool Filters!

If yous accept any questions almost How To Backwash A Pool Sand Filter In 10 Elementary Steps delight feel complimentary to go out a message!